Port Weller (1 gal)

1 Gal Bruce Trail.jpg
Color Pallete PW.jpg
1 Gal Bruce Trail.jpg
Color Pallete PW.jpg

Port Weller (1 gal)

from 0.00

Interior Latex Paint

  • Smooth, Durable Coverage
  • Low VOC
  • Low Sheen
  • 95% Post-Consumer Recycled Paint
  • 100% Post-Consumer Recycled Plastic Container
  • Available in 11 Port Weller Colors
  • Max. 1,800 gal. per Batch
  • MPI #44-RC
Add To Cart

SURFACE PREPARATION AND USE  The short version: Use and prepare PWPC (Port Weller Paint, Co.) as you would any other mid-grade low-gloss latex interior paint.  The long version: Surface must be free of oil, dust, soap, wax, mold, rust, etc. If in doubt of surface state, wash well with TSP, then rinse and dry. Priming is always recommended but PWPC can go over other low-gloss clean latex substrates.While factors affecting performance may vary, PWPC is not recommended for high wear or wet areas such as kitchen backsplashes, bathrooms, and trim.

APPLICATION  PWPC can be applied by brush, roller, or sprayer (follow sprayer instructions).

SAFETY Use in a well-ventilated area and keep out of reach of children. If swallowed, call poison control or see a doctor immediately. If in eyes or on skin, rinse well.


  • Color match: < 0.8 delta
  • Gloss: 3.5 - 7 units at 60 degrees
  • Viscosity: 90-100 Krebs units at 77 degrees
  • Coverage: 350-450 square feet per gallon
  • Volatile Organic Compounds (VOC’s): Test ranges from 17-39 g/l (ppm)
  • Re-coat time: 30 minutes at 77 degrees
  • Dry time: 4 hours
  • Cure time: 10 days
  • Density: 9.6-10.6 lbs. per gallon